New add-on: Central Maintenance Computer for PSX (CMC-PSX)...now v1.14

[Avi]

Hi,

29-32 is the Hydraulic Fluid Overheat Warning System (it only provides the warning) while 29-11 is the system itself.
You can get an engine pump or demand pump failure message and this is under 29-11.

Cheers,

[jawomba]

Thank You, I understand.

Jan

[Avi]

Hi all,

With the release of SRSL-PSX I release also a new version of CMC-PSX (v1.14). In this version:

  · v1.13 introduced a new setting tab. Changing the IP address didn't have any effect. Now it does
  · Messages area was modified from TextArea to JTextArea. It looks better
  · The prompt of the addon in the CDU was changed to <CMC or CMC> ( no more CMC-PSX)
  · Flight phase 'Pre Flight' (for malfunction messages) was set too early during 'Shut Down' and not after 'Power Up'. Fixed
  · EGPWS ground and confidence test were modified and now after completion of the CMC-PSX part, a signal is sent to SRSL-PSX to start its part of the test. After CMC-PSX sends it signal, it waits about a second to get response to know SRSL-PSX is there and ON, After that (if it's on) CMC-PSX waits until it gets a test end signal or it ends the test after 95 seconds (which is the time for full SRSL-PSX test time). After completion of the SRSL-PSX part (or immediately if it doesn't exist), a PASS / FAIL results is displayed as usual. During the test in SRSL-PSX, only the files that belong to the enabled subsystems (please read the SRSL-PSX user guide to understand this part) are played so the test can be very short (if only one small subsystem is enabled).

To get the new version all you need to do is download CMC-PSX.jar and override the old one.

That's it,

Have fun,