New add-on: Central Maintenance Computer for PSX (CMC-PSX)...now v1.15

[Avi]

Hi,

29-32 is the Hydraulic Fluid Overheat Warning System (it only provides the warning) while 29-11 is the system itself.
You can get an engine pump or demand pump failure message and this is under 29-11.

Cheers,

[jawomba]

Thank You, I understand.

Jan

[Avi]

Hi all,

With the release of SRSL-PSX I release also a new version of CMC-PSX (v1.14). In this version:

  · v1.13 introduced a new setting tab. Changing the IP address didn't have any effect. Now it does
  · Messages area was modified from TextArea to JTextArea. It looks better
  · The prompt of the addon in the CDU was changed to <CMC or CMC> ( no more CMC-PSX)
  · Flight phase 'Pre Flight' (for malfunction messages) was set too early during 'Shut Down' and not after 'Power Up'. Fixed
  · EGPWS ground and confidence test were modified and now after completion of the CMC-PSX part, a signal is sent to SRSL-PSX to start its part of the test. After CMC-PSX sends it signal, it waits about a second to get response to know SRSL-PSX is there and ON, After that (if it's on) CMC-PSX waits until it gets a test end signal or it ends the test after 95 seconds (which is the time for full SRSL-PSX test time). After completion of the SRSL-PSX part (or immediately if it doesn't exist), a PASS / FAIL results is displayed as usual. During the test in SRSL-PSX, only the files that belong to the enabled subsystems (please read the SRSL-PSX user guide to understand this part) are played so the test can be very short (if only one small subsystem is enabled).

To get the new version all you need to do is download CMC-PSX.jar and override the old one.

That's it,

Have fun,

[Kurt]

Hi Avi.

I somehow cannot change the port number in CMC.

Even when editig the CMC-PSX.ini file and changing PORT=10747 to PORT=10748 and saving - as soon as I start CMC it is resets back to PORT=10747.

Thanks

[Avi]

Hi Kurt,

Yes, I hard coded the port number to 10747 in v1.12 (Oct 2022) as I saw no reason to change it.

As in SRSL-PSX, I will re-modify it. Can't promise it will happen this weekend (too many things build up) but next week (if not in between as it is not a big deal).

Cheers,

[voipmeister]

Thanks Avi!
This will allow us to point CMC-PSX to a main instance instead of the client router some of us have running in our shared cockpit setups (it will prevent multiple CMC-PSX instances injecting data in a shared PSX network).

[Avi]

CMC-PSX v1.15 is up.

Port number in the Setting tab can be modified.

Cheers,

[Kurt]

Port number in the Setting tab can be modified.

Thanks Avi - I can confirm it works

Cheers